arduino-esplora
arduino-esplora-.2arduino-esplora-3

Arduino Esplora

S/224.00


Warning: sizeof(): Parameter must be an array or an object that implements Countable in /homepages/19/d776646349/htdocs/clickandbuilds/IDIElectronica/wp-content/plugins/woocommerce/templates/single-product/meta.php on line 26

Descripción del producto

The Arduino Esplora is a microcontroller board derived from the Arduino Leonardo. The Esplora differs from all preceding Arduino boards in that it provides a number of built-in, ready-to-use set of onboard sensors for interaction. It’s designed for people who want to get up and running with Arduino without having to learn about the electronics first. For a step-by-step introduction to the Esplora, check out the Getting Started with Esplora guide.

The Esplora has onboard sound and light outputs, and several input sensors, including a joystick, a slider, a temperature sensor, an accelerometer, a microphone, and a light sensor. It also has the potential to expand its capabilities with two Tinkerkit input and output connectors, and a socket for a color TFT LCD screen.

Like the Leonardo board, the Esplora uses an Atmega32U4 AVR microcontroller with 16 MHz crystal oscillator and a micro USB connection capable of acting as a USB client device, like a mouse or a keyboard.

In the upper left corner of the board there is a reset pushbutton, that you can use to restart the board. There are four status LEDS :

  • ON [green] indicates whether the board is receiving power supply
  • L [yellow] connected directly to the microcontroller, accessible through pin 13
  • RX and TX [yellow] indicates the data being transmitted or received over the USB communication

The board contains everything needed to support the microcontroller; simply connect it to a computer with a USB cable to get started.

The Esplora has built-in USB communication; it can appear to a connected computer as a mouse or keyboard, in addition to a virtual (CDC) serial / COM port. This has other implications for the behavior of the board; these are detailed on the getting started page.

Ficha técnica

Voltaje de Operación 5V DC
Microcontrolador ATmega32u4
Memoria Flash 32 KB of which 4 KB used by bootloader
SRAM 2.5 KB
EEPROM 1 KB
Frecuencia del Crystal 16 MHz

Valoraciones

No hay valoraciones aún.

Sé el primero en valorar “Arduino Esplora”