CRAZYFLIE 2.0 DRONE

CRAZYFLIE 2.0 DRONE

S/589.00


Warning: sizeof(): Parameter must be an array or an object that implements Countable in /homepages/19/d776646349/htdocs/clickandbuilds/IDIElectronica/wp-content/plugins/woocommerce/templates/single-product/meta.php on line 26
Categorías: ,

Descripción del producto

Specification

 

  •   Mechanical specs:
  •   Weight: 27g
  •   Size (WxHxD): 92x92x29mm (motor-to-motor and including motor mount feet)
  •   Radio specs:
  •   20 dBm radio amplifier tested to > 1 km range LOS with Crazyradio PA
  •   Bluetooth Low Energy support with iOS and Android clients available (tested on iOS 7.1+ and Android 4.4+)
  •   Radio backwards compatible with original Crazyflie and Crazyradio
  •   Micro-controllers:
  •   STM32F405 main application MCU (Cortex-M4, 168MHz, 192kb SRAM, 1Mb flash)
  •   nRF51822 radio and power management MCU (Cortex-M0, 32Mhz, 16kb SRAM, 128kb flash)
  •   uUSB connector
  •   On-board LiPo charger with 100mA, 500mA and 980mA modes available
  •   Full speed USB device interface
  •   Partial USB OTG capability (Usb OTG present but no 5V output)
  •   IMU:
  •   3 axis gyro (MPU-9250)
  •   3 axis accelerometer (MPU-9250)
  •   3 axis magnetometer (MPU-9250)
  •   high precision pressure sensor (LPS25H)
  •   Flight specification:
  •   Flight time with stock battery: 7 minutes
  •   Chraging time with stock battery: 40 minutes
  •   Max recommended payload weight: 15 g
  •   Expansion connector with:
  •   VCC (3.0V, max 100mA)
  •   GND
  •   VCOM (unregulated VBAT or VUSB, max 1A)
  •   VUSB (both for input and output)
  •   I2C (400kHz)
  •   SPI
  •   2 x UART
  •   4 x GPIO/CS for SPI
  •   1-wire bus for expansion identification
  •   2 x GPIO connected to nRF51
  •   8KB EEPROM

 

Package Contents:

  • ? 1 x Crazyflie 2.0 control board with all components mounted
  • ? 5 x CW propellers
  • ? 5 x CCW propellers
  • ? 5 x Motor mounts
  • ? 1 x LiPo battery (240mAh)
  • ? 5 x Coreless DC motors
  • ? 2 x Short expansion connector pins (1×10, 2mm spacing, 8 mm long)
  • ? 2 x Long expansion connector pins (1×10, 2mm spacing, 14 mm long)
  • 1 x Battery holder expansion board

Valoraciones

No hay valoraciones aún.

Sé el primero en valorar “CRAZYFLIE 2.0 DRONE”